Japanese Acupuncture And Moxibustion

Sugiyama also revitalized the concept of root treatment and branch treatment . JAKE PAUL FRATKIN, OMD has been in practice since 1978, following an apprenticeship training in Meridian Therapy with Dr. Ine Moon.
Acupuncture needles of sterilized single usage type (140–160 μm) in diameter, Seirin Co. A specific needling point for throat pain relief founded by Japanese acupuncturist Yoneyama was used. The acupuncture needle was gently inserted then manipulated for inducing ‘de-qi’ sensations which project deep into the throat and continued for 15 s bilaterally.



Since that time, Moxa has been developed into several different styles throughout China, Korea, and Japan. Today, Japan has specialists that complete years of training and only work with Moxa therapy. I would happily recommend everyone to take opportunity using this ecperience. Europeans placed sprigs of mugwort under pillows to provoke dreams; and the herb had associations with the practice of magic in Anglo-Saxon times. The first modern scientific publication on moxibustion was written by the Japanese physician Hara Shimetarō who conducted intensive research about the hematological effects of moxibustion in 1927. Two years later his doctoral dissertation on that matter was accepted by the Medical Faculty of the Kyūshū Imperial University. Scrofula was to be treated at the point where it occurred, with garlic-partition moxibustion .
In modern practice the herb is usually crushed, wrapped in special paper, and, when lit, held above the point to be warmed or placed on the skin and removed before overheating occurs. The Japanese developed small tubes, fitted with handles, in which the powdered plant is burned away and heating is controlled by the therapist. A moxa stick burns for four or five minutes and is used to relieve pain and congestion and to provide an anesthetic effect.

It is effective for chronic organ problems as well as various pain presentations. For Dr. Harada the prime importance is that the patient is in a state of constant relaxation and calm throughout the session. Promotion of a safe atmosphere and a painless feather like touch when inserting his needles are all standard practices incorporated in his sessions. Dr. Harada does not leave the patient after all the needles have been placed upon the body. Instead he stays in the room and insures the healing process is carried out according to traditional diagnosis. He is also versed in the methods of Joint Mobilization as a technique used to increase the range of motion of an injured limb and also to align the articulating surfaces of a joint and to reduce joint play.
Temperature distribution on the surface of the rubber sheet heated by the radiation heater. We used a halogen lamp with a rated power of 75 W (J12V75W-AXS, manufactured by Mitsubishi Electric Osram), available on the market, as the light source. However, we controlled the radiation intensity by using the power supply device adjustably with a power load lower than the rated power. We used a remodelled Maglite 4-Cell D Flashlight (manufactured by Mag Instrument, Inc.) as the reflection mirror. The reflection mirror is a parabolic mirror, which makes it possible to emit near-parallel light by adjusting the light source to the focal point position of the parabolic mirror.
Indirect moxibustion holds a cigar made of moxa near the acupuncture point to heat the skin, or holds it on an acupuncture needle inserted in the skin to heat the needle. Japanese acupuncturists almost always incorporate moxibustion into their treatment. This involves burning cones of moxa over the patient’s skin before needling.

Temperature distribution of the rubber membrane heated by moxa needle. Figure 11C shows the distribution of temperature caused by kyutoshin heating of the rubber membrane surface. The figure indicates the temperature distribution when the temperature is at its highest during the burning of the moxa. This graph depicts a certain line on the horizontal axis, which delineates an image taken with an infrared thermograph. This indicates that the temperature at the centre had reached the level that causes burn injuries, while at the same the temperature of the surrounding area remained low. The configuration of the pencil shape is the same as the disc shape, and the heating part is made of copper and coated with gilding. The heating part, which makes contact with the skin, can be replaced with different sizes.
Figure 10 shows the configuration and a picture of the pencil-shaped device. Direct moxibustion requires more experienced clinical practice than material-mediated moxibustion to be safe and effective. Also, the moxa used in direct moxibustion must be smaller and easier to harden than the moxa used in indirect moxibustion. The temperature can be set between 41°C and 45°C, within 1°C units. The thermostat is used to protect the aluminium plate from overheating. Unlike the first device, this device can be used while the patient is moving; thus, its usability has a wider range.

The second characteristic of Japanese acupuncture is a unique needle technique. The needles that are used are quite thin by comparison to those used in Chinese style acupuncture. Most practitioners will use needles with gauge #1 (.16 mm) or less. Many practitioners are so adept with insertion tubes, that they can pull and reinsert a needle back into the tube with one hand as they use the other hand to search for the next insertion. Many styles, particularly Meridian Therapy, use shallow insertion, sometimes as little as 1 mm. . As an example of the finesse that is possible in palpatory diagnosis, I watched a blind master of the Toyo Hari tradition give instruction. As he felt the radial pulse on a prone student, he asked another student to locate LI 11 on the opposite arm.
Figure 4 shows the formula of proportional control to determine the average of heat quantity. Acupuncture and moxibustion On/off control is used to control the preset temperature and heating rate.

Acupuncture employs a variety of techniques to stimulate and improve your energy flow, including placing extremely thin sterile needles into specific points on the body. Acupuncture can be used to to treat diseases, to promote general health, and for therapeutic purposes. Japanese acupuncture strengthens the smooth flow of Ki within the 12 meridians to support the body's ability to function optimally, resist illness, reduce inflammation, and resolve causes of pain. Each session includes a root treatment that focuses on building overall core health and resilience along with a branch treatment that addresses current health concerns. This gentle treatment style is well-suited for elders, sensitive patients, people with anxiety, and individuals with chronic illness. Additionally, Japanese acupuncturists often use okyu, or "thread moxibustion," to add to the soothing nature of Japanese acupuncture.
About 97 percent of the mugwort is eliminated through this process to produce Gold Moxa. Lesser quality moxa is simply spun less and retains more plant fiber, which makes it less pure and therefore less expensive. These screens act like filters, keeping the light moxa hairs up top. ​On this tour, I had the opportunity to visit two different moxa companies. Our first site visit was to the Yamasho Moxa Factory in Shiga Prefecture. Here I had the chance to see each step taken in their process of turning mugwort into moxa.

Leave a Reply

Your email address will not be published. Required fields are marked *